NS0-182 Online Practice Questions and Answers

What is the maximum port speed of an Ethernet port on a Cisco Nexus 3232C cluster-interconnect switch?

A. 40GbE

B. 200GbE

C. 10GbE

D. 100GbE

Starting with ONTAP 9.5, what is the maximum number of HA pairs that are supported when using a SAN cluster?

A. 4

B. 2

C. 6

D. 8

You have just installed a new FAS2620 on a cluster site. You are using the USB cable for the intial configuration.

In this scenario, what is the default speed for the serial connection?

A. 9600 bps

B. 15200 bps

C. 576000 bps

D. 115200 bps

You are cabling two Cisco 3232C switches for the cluster interconnect of a 4-node AFF A800 cluster.

Which pair of ports are used to cable the Inter-Switch Link (ISL) between the switches?

A. 1/21 to 1/24

B. 0/13 to 0/16

C. 1/31 and 1/32

D. 0/1 and 0/2

You just finished an AFF A300 installation with two DS224C disk shelves. What are two ways to cable these disk shelves? (Choose two.)

A. Use alternative control path.

B. Use single-path HA.

C. Use quad-path HA.

D. Use multipath HA.

While troubleshooting an issue with a newly installed system, you used the system controller environment show command.

In this scenario, which issue would be diagnosed with this command?

A. shelf cabling issues

B. controller configuration issues

C. controller hardware issues

D. controller version issues

You complete a hardware installation on a CN1610 switch and establish a serial connection to the RJ45 port.

In this scenario, the established serial connection allows the installer to complete which two tasks for the switches initial configuration? (Choose two.)

A. to view network information that has been dynamically assigned to the management interface by the DHCP server on the network

B. to use the serial port connection as a diagnostic channel to the second CN1610 switch in the cluster interconnect

C. to configure the switch with another CN1610 switch using Cross-Stack EtherChannel configuration for load balancing and performance

D. to manually configure the static network information

You are performing a nondisruptive image upgrade of a CN1610 switch. You verify that there are no path failures on the switch.

What is the next step in this process?

A. Run the write memory command.

B. Run the reload command.

C. Backup the current running image using the copy active backup command.

D. Reboot the switch.

In which two configurations would Advanced Drive Partitioning be used by default in ONTAP 9.5? (Choose two.)

A. an AFF A700 with one DS2246 shelf containing 24 960GB SSDs

B. a FAS2554 with 24 internal 1000 GB SATA HDDs

C. a FAS8040 with one DS2246 shelf containing 24 900 GB SAS disks

D. a FAS9000 with one shelf DS212C with 24 800 GB SAS HDDs

While preparing for a new ONTAP installation, you discover an issue with the controllers that are running ONTAP 9.5. The issue is not affecting controllers that are running ONTAP 9.4 with the latest patch version.

In this scenario, which two steps should you perform to solve the problem? (Choose two.)

A. Review the issue with the customer's deployment to see if it would be affected.

B. Inform your customer that they must always install the latest supported ONTAP release.

C. If the controllers are in a Product Support Bulletin with ONTAP 9.5, open a case and wait for support to provide a patch release.

D. Download ONTAP 9.4 with the latest patch version and ONTAP 9.5 for an eventual rollback on the day of the installation.