NS0-160 Online Practice Questions and Answers

When a write from a SAN host is received, the information is stored within the controller before it is written

to the underlying RAID.

In this scenario, which component stores the data?

A. HBA

B. FlashCache

C. Flash Pool

D. NVRAM

A customer has four or more nodes in a cluster. More than four target ports are being used by the SVMs in

any node. The customer wants to limit the number of paths that can be used to access LUNs on the nodes,

so that the paths do not exceed the recommended maximum of eight.

In this scenario, which three actions will accomplish this task? (Choose three.)

A. Use ALUA protocol.

B. Use multipathing software.

C. Use port sets for iSCSI.

D. Use Selective LUN Mapping

E. Use FC switch zoning.

To which three objects on an ONTAP 9.3 cluster would you assign a QoS throughput floor? (Choose three.)

A. a volume on FAS

B. a LUN on AFF

C. a volume on AFF

D. an SVM on AFF

E. a file on AFF

Which command shows the data compaction savings for an aggregate?

A. storage aggregate show-space

B. storage aggregate show-efficiency

C. volume efficiency show

D. storage efficiency show

Which FabricPool policy would you apply only on a SnapMirror destination volume?

A. backup

B. destination

C. auto

D. manual

Which ONTAP feature uses the Service Processor to speed up takeover times between HA pairs?

A. hardware-assisted takeover

B. automatic takeover and giveback

C. epsilon

D. cluster HA

Regarding root partitioned disks in an ONTAP system, which three types of objects are associated with ADP? (Choose three.)

A. array LUN

B. root partition

C. container disk

D. data partition

E. shared disk

An administrator forgot to update the cabling sheet for a core Cisco switch and cannot recall which ports

were used by the NetApp FAS system.

Which command should the administrator run to obtain this information?

A. network port show

B. network device-discovery show

C. network interface show

D. network port broadcast-domain show

Which two configuration limits should you verify when you add additional storage to an AFF A300 switchless configuration? (Choose two.)

A. the supported number of SSD disks for the A300 system

B. the supported number of shelves

C. the supported number of HDDs for the A300 system

D. the supported number of FC initiator ports for the A300 system

Which statement is true about creating volumes that contain LUNs?

A. You can create LUNs on an aggregate.

B. You cannot create qtrees on a volume that contains LUNs.

C. You cannot create LUNs on an SVM root volume.

D. You cannot add files on a volume that contains LUNs.