HPE6-A29 Online Practice Questions and Answers

A company uses Aruba Mobility Controllers and Aruba Aps. The Aps incur a power outage.

Which Aruba feature should be implemented to allow the surrounding Aps to provide wireless coverage for the area of the AP that lost power?

A. Airtime Fairness

B. Adaptive Radio Management

C. Band Balancing

D. High Availability

Aruba Client Match does NOT use which of the following parameters to determine the best AP for a client connection?

A. Device type

B. Location

C. Signal to Noise Ratio

D. Access Point load

E. Spectrum Analysis

Which of the following will accept named VLANs as a parameter? (Choose three)

A. a VLAN pool

B. User Role for single VLAN

C. RADIUS Server attributes for role derivation

D. Firewall session rule

E. Port trunk configuration

Fast Failover has been implemented between Local 1 and Local 2 separated by Routers. During testing

Local1 was disabled and all Campus APs backed up to Local 2 flawlessly.

But the RAPs did not, they all failed.

What could be the cause?

A. RAPs should be configured in their own AP-groups

B. A VPN IP Pool must be configured on Local 2

C. The RAP whitelist must be ported over to Local 2

D. IPSec must be enabled on Local 2

E. RAPs are not supported by Fast Failover

Referring to the diagram provided for this question, an employee brought an unauthorized AP from home and attached the LAN port to the cubicle Ethernet port. All Aruba APs and AMs as well as the employee AP are in VLAN 80 and within RF range of each other. No traffic from the wired or wireless network has passed through the unauthorized AP yet, but the AP began wireless broadcasts.

How will the Aruba system initially classify the employee's non-Aruba AP?

A. a valid AP

B. an AM

C. a Rogue AP

D. an interfering AP

E. a known interfering AP

Which of the following APs support remote AP operation?

A. AP 105

B. AP 125

C. RAP2

D. All of the above

The above diagram has one master and three local controllers. AP1 GRE terminates on controller Local 1.

All controllers are configured with the wireless user VLAN 201. A wireless user associates with AP 1. Only L2 mobility is enabled.

Which elements will know about this association?

A. Local 1 only

B. Local 1 and the Master

C. Local 1 and Local 2 and the Master

D. Local 1 and AP1

E. All Controllers

In the diagram provided for this question, the client laptop is associated with the Aruba AP. The Aruba controller is configured to perform L2 switching for this SSID.

What will be the client laptop default gateway?

A. A

B. B

C. C

D. D

E. E

By default Centralized licensing messages between master and local controllers are sent ___________________.

A. In the clear unencrypted since the master and local controllers already share IPSEC tunnels.

B. Using CPSec

C. Using IPSec site to site VPN tunnels

D. Encrypted using GRE

E. PAPI

ip access-list session anewone user network 10.1.1.0 255.255.255.0 any permit user host 10.1.1.1 any deny

user any any permit Referring to the above portion of a Mobility Controller configuration file, what can you conclude? (Choose two)

A. This is a session firewall policy.

B. This is an extended Access Control List (ACL).

C. Any traffic going to destination 10.1.1.1 will be denied.

D. Any traffic going to destination 10.2.2.2 will be denied.

E. Any traffic going to destination 172.16.100.100 will be permitted.