EW0-200 Online Practice Questions and Answers

What is the default value for the RIP garbage-time setting?

A. 30 seconds

B. 60 seconds

C. 120 seconds

D. 240 seconds

The acronym TCP/IP stands for:

A. Transport Control Protocol/Internal Protocol

B. Transmission Control Protocol/ International Protocol

C. Transfer Control Policy/Interactive Protocol

D. None of these

How can you tell by looking at the front panel of an Summit 1i switch, which ports are disabled?

A. Flashing amber light

B. Flashing green light

C. Solid amber light

D. Solid green light

In normal IP unicast routing, all forwarding decisions are based on the ______________ of each packet.

A. destination MAC address

B. source IP address

C. source MAC address

D. destination IP address

Given the following diagram, which command would you use to send the switch active configuration file to the TFTP server?

A. download config 192.168.0.1

B. upload config 192.168.0.254

C. download config 192.168.0.254

D. upload config 192.168.0.1

Given the following diagram, which command would you use to send a switch configuration file from the TFTP server to the switch?

A. download config 192.168.0.254

B. download config 192.168.0.1

C. upload config 192.168.0.254

D. upload config 192.168.0.1

The Extreme switch ASIC look-up Host Table containing IP host routes, outbound VLAN interfaces and ports is called:

A. IP Route Table

B. IP ARP Table

C. IP FDB

In addition to maintaining an internal log, the switch supports remote logging by way of the UNIX syslog host facility. What would you do to enable remote logging on an Extreme switch?

A. Configure the syslog host to accept and log messages

B. Enable remote logging on the switch using the CLI command: enable syslog

C. Configure remote logging using the CLI command: config syslog add

D. All of these

What is the theoretical total convergence time when 802.1D STP has to recalculate its tree because of a failure of the root bridge?

A. 15 seconds

B. 30 seconds

C. 50 seconds

D. 60 seconds

The CLI command to disable poison reverse on an Extreme switch is:

A. disable rip poisonreverse noadvertise

B. disable poisonreverse rip noadvertise

C. disable rip poisonreverse

D. disable poisonreverse rip