DES-4421 Online Practice Questions and Answers

DRAG DROP

An administrator is using the OME-M GUI to change the hostname on an unconfigured I/O module inserted in slot A1. They log on to the MX7000 chassis home page.

What is the correct order of steps the administrator should take to set the management IP address?

Select and Place:

DRAG DROP

Match the M840c components to the callouts shown in the exhibit.

Select and Place:

A server sled has a single mezzanine card installed in the correctly supported slot. To which IOM fabric(s) does the sled have access?

A. Fabric A1 and Fabric A2

B. Fabric A1 only

C. Either Fabric A or Fabric B, depending on the configuration set in OME-M

D. Fabric A1 and Fabric B1

What is a valid option when resetting iDRAC to factory defaults?

A. Preserve user and network settings

B. Preserve network and storage settings

C. Preserve identity and network settings

D. Preserve storage and user settings

What is a benefit of SmartFabric Services Mode?

A. Topology validation and self-healing

B. Load balancing for management layers

C. Load balancing for application layers

D. Automatic detection of packet collisions

A technician has replaced an MX chassis tub. They complete the tub installation and power on the chassis. They notice that the KVM is no longer functional. What should the technician do after confirming the KVM feature is still enabled in OME-M?

A. Ensure all cables connecting the tub to the left ear control panel are connected properly

B. Ensure all power supplies are connected and powered-on

C. Ensure all cables connecting the tub to the right ear control panel are connected properly

D. Ensure all installed Management Modules are connected to the network

An administrator is asked to install and power-on a new MX740c sled in an MX7000 chassis. The administrator inserts the sled and presses the power button. They notice that the power button LED is blinking green. After a short time power button turns to solid green and the server finally turns on.

What operation was in progress when the power button was blinking green?

A. iDRAC was booting

B. Lifecycle Controller update was in progress

C. Lifecycle Controller was taking firmware inventory

D. iDRAC was updating firmware

What type of connection is used by QuickSync 2?

A. Bluetooth

B. NFC

C. QuickAssist

D. LTE

Which feature requires an iDRAC Enterprise license for an MX sled?

A. iDRAC Service Module

B. Last Crash Screen

C. Group Manager

D. Storage Management

Refer to the exhibit.

What is shown?

A. MX5000s

B. MX5108n

C. MX5016s

D. MXG610s