DC0-200 Online Practice Questions and Answers

What are three recommended solutions for resolving the error with a NIC which stop s communicating? (Choose three.)

A. You install a different adapter in the same slot.

B. You remove and reinstall the drivers.

C. You confirm the Device List. Ctrl setting is set to Adapter-Enabled.

D. You reseat the adapter in its slot or a different slot.

Which command line syntax assigns asset tag 12345 to a PowerEdge server using the Asset Tag Utility?

A. asset /d 12345

B. asset /s 12345

C. asset /c 12345

D. asset /r 12345

E. asset 12345

The system administrator of a mixed network environment consisting of both Microsoft Windows 2000 and Red Hat Linux wants to take advantage of the embedded NICs on the PowerEdge 2650 servers for network load balancing. Which scenario would work ?

A. You cannot configure network load balancing in multiple Network Operating Systems.

B. configure Windows 2000 servers to use IPX and Linux servers to use IP

C. configure Windows 2000 servers to use IP and Linux servers to use IP

D. configure Windows 2000 servers to use IP and IPX and Linux servers to use IP and IPX

If there is a loss of power redundancy on your PowerEdge server, in which three ways can Dell OpenManage IT Assistant report this? (Choose three.)

A. Dell IT Assistant sends an alert to Dell OpenManage Server Administrator.

B. The status panel for that system indicates which power supply failed.

C. An SNMP trap can be logged in the OpenManage IT Assistant.

D. Systems Status is marked as "Warning" in OpenManage IT Assistant.

Why is memory interleaving used?

A. to provide speed improvements by accessing memory in parallel

B. to provide speed improvements by allowing addressing to be set for the next access to the same DIMM, while data are being read from the previous access

C. to provide redundancy by maintaining parity information on the DRAM to detect and correct single bit errors

D. to provide redundancy by allowing defective memory to be disabled

What are three types of NIC teaming? (Choose three.)

A. Load Balancing

B. Fault Tolerance C. Generic Trunking D. Cluster Teaming

A PowerEdge server contains 8 GB of memory. During the POST sequence, only 256 MB is shown.

What is the most likely problem?

A. The memory card is in Safe Mode.

B. The memory card needs to be reseated.

C. There is a PERC card installed.

D. The processor stepping is mismatched.

E. OS Install Mode is enabled in the System Setup.

You can use OMSA to remotely update the firmware for which two components? (Choose two.)

A. host bus adapter firmware

B. BIOS

C. system software

D. Remote Access Controller firmware

What is the benefit of ECC memory?

A. provides redundancy by maintaining parity info on the DRAM to detect and correct single bit errors

B. provides redundancy by allowing defective memory to be disabled

C. provides speed improvements by allowing addressing to be set for the next access to the same DIMM, while data are being read from the previous access

D. provides speed improvements by accessing memory in parallel

Which four steps are necessary for creating a team in Windows 2000 using BASP? (Choose four.)

A. create a team and assign it a name

B. configure the IP address and subnet mask for the team

C. select the adapters from the list to add to the team

D. set the media type for the adapters

E. select the Broadcom Advanced Server Program Driver

F. enter the path and filename of the configuration to be saved