ACMP_6.4 Online Practice Questions and Answers

Which of the following APs do NOT support dual radio operations? (Choose two)

A. AP 93

B. AP 105

C. RAP 3WN

D. AP 224

E. AP 135

Which netdestination aliases are built into the controller? (Choose three)

A. logon

B. any

C. user

D. guest

E. localip

Which actions does ARM (Adaptive Radio Management) perform? (Choose two)

A. allows controllers to provision the AP Radio type

B. allows controllers to provision the best channel for APs

C. allows controllers to provision the best power setting for APs

D. allows controllers to provision allowed Radio bands

E. allows controllers to provision lower power when unauthorized APs are detected

A campus AP has been provisioned with a VAP in bridge forwarding and standard operation modes. Which of the following authentication types are supported? (Choose two)

A. 802.1X authentication

B. Open System authentication

C. Local authentication

D. Captive portal authentication

E. VPN authentication

When direct consoled to an AP, what is the command sequence to factory default the AP and re-bootstrap?

A. setenv bootstat init

B. setenv master init, boot

C. purge, save, boot

D. init, save, boot

E. printenv, purge, boot

What is the total number of charts you can simultaneously monitor in a spectrum dashboard?

A. 3

B. 4

C. 8

D. 9

E. 12

Which parameter(s) does a Master controller use to determine where a provisioned AP should terminate its GRE tunnel?

A. the IP address of the AP

B. the MAC address of the AP

C. the IP address of the switch nearest to the AP

D. the name and group settings of the AP

E. the VLAN the AP is attached to

A client device associates with an SSID provisioned with 802.1X authentication. The client is set for PEAP authentication. EAP termination (AAA Fastconnect) is disabled on the controller. But the client continuously cycles through the authentication process. Which of the following could cause this? (Choose two)

A. The client is provisioned with the wrong EAP type.

B. The client has an expired or revoked server certificate.

C. The DHCP server is not enabled.

D. The VLAN is missing for the SSID.

E. The controller does not support PEAP in this mode.

When configuring split tunnel mode on a Remote AP (RAP) where is the routing function for the split tunnel defined?

A. On the IP routing tab in the configuration screen.

B. On the AP provisioning screen.

C. In the RAP static routing tables

D. In the Firewall policy

E. In the RAP whitelist

What is the function of Station Handoff Assist, if enabled?

A. Force device to 5Ghz band

B. Force device off AP if RSSI is below threshold

C. Send message to device to change AP

D. Send message to adjoining AP to accept device

E. Send message to adjoining AP to initiate association to the device