830-01 Online Practice Questions and Answers

When configuring failover, in what manner must you configure your Steelhead appliances? 1) Master/Backup 2) Primary/Secondary/Tertiary 3) Master/Master 4) Backup/Backup 5) Primary/Principle

A. 1

B. 2

C. 3, 4

D. 1, 3, 4

E. 1, 2, 3, 4, 5

A Steelhead Mobile client can be configured to operate in visible or invisible mode (show client in system tray parameter). What part of the configuration is this setting included?

A. Acceleration policy

B. Authentication policy

C. Endpoint policy

D. Port labels

Which statement is true regarding "fair-peering"?

A. It is a default parameter

B. It enables load distributed using round-robin

C. It enables load distribution using peer affinity

D. It can be configured as part of a load-balancing rule

E. It automatically redistributes connections equally among all appliances in a cluster when a new appliance is added to the local cluster

Using an Interceptor appliance is an alternative to what network designs? (Select 2)

A. WCCP

B. PBR

C. Connection Forwarding

D. Fixed-target rules

E. Peering rules

The Interceptor appliance will attempt to redirect a connection to a Steelhead appliance in the auto pool: A. When no user defined Load Balancing rules matches AND peer neighbors are defined

B. When no user defined Load Balancing rules matches AND no peer neighbors are defined

C. When no peer Interceptor appliances are defined

D. When a user-defined Load Balancing rule matches AND a target Steelhead appliance is available

What command should you use to see the direct URL of a package?

A. show rsp slots

B. show rsp modules

C. show rsp platform

D. show rsp packages

E. show rsp vms

A fat pipe is a network that can carry large amounts of data without significantly degrading transmission speed. If you have a fat pipe that is not being fully utilized and you are experiencing WAN congestion, latency, and packet loss as a result of the limitations of regular TCP, which of the following RiOS features will help? (Select 2)

A. Enable Forced Burst TCP (FB-TCP)

B. Enable HighSpeed TCP (HSTCP)

C. Disable admission control

D. Lower the Advanced Security Checkflow Parameter (ASCP)

E. Enable Maximum TCP (MX-TCP)

F. Enable disk encryption

Refer to the exhibit.

A connection times out when Client41 and Client42 attempt to either establish an HTTP session to Server31 or an FTP connection to Server32 after not connecting to them for some time. The very next attempt to connect to these services done immediately after the failure seems to work correctly. The clients are able to ping both servers and no access-lists are configured on the routers. SH3 uses the IP address of R3f0 as its default gateway. Upon powering off SH3 and SH4, the problem goes away even for first connection and everything works normally (even after not connecting for extended periods of time). Which of the following are likely to correct this problem?

A. Both servers have faulty network interface cards and should be replaced

B. Both the HTTP service running in Server31 and the FTP service running in Server32 are down and should be restarted

C. A more specific static route pointing to Subnet 31 is not configured at SH3

D. A more specific static route pointing to Subnet 31 is not configured at R3

E. A more specific static route pointing to Subnet 31 is not configured at L3 Switch

What is contained in the probe of the return SYN/ACK packet when using enhanced auto-discovery (EAD)?

A. 4 bytes of notification

B. 10 bytes of TCP inner channel setup + 2 bytes of notification

C. 14 bytes of TCP inner channel setup + 4 bytes of notification

D. 18 bytes of TCP inner channel setup + 4 bytes of notification

E. 32 bytes of TCP inner channel setup + 2 bytes of notification

Up to how many TCP connections can the Interceptor 9600 handle?

A. 1,000,000

B. 1,500,000

C. 2,000,000

D. 2,500,000

E. 3,000,000