VMware 5V0-41.20 Exam Dumps

Scenario 3:

After resolving numerous connectivity issues throughout the various branch sites, connectivity between applications and users is finally present. The network administrator is informed that during certain tests, applications are not performing as they are expected to. Users report that call quality has not fully improved and that some of their calls either drop or have poor voice quality where the conversation is breaking up. Other users are noticing that file transfers are slower than expect. A group of users from a few sites have reported slowness in accessing internal and external applications.

Exhibit.

Users at a remote office are complaining about poor performance with certain applications. The network administrator has already configured Business Policies based on these requirements.

What is the sequence of parameters that the administrator can check to troubleshoot this problem? (Choose two.)

A. Change the bandwidth measurement under WAN Overlay Advanced Settings.

B. Check underlay network (bandwidth, latency, jitter, packet loss).

C. Under Monitor, check Routing tab.

D. Review Business Policies configuration and match them against the business requirements.

Scenario 2:

After completing the branch activation activities for all required branches, the network administrator attempts to test connectivity between the various branches and between the hubs and branches. The administrator notices a lack of connectivity despite being certain that configurations have been complete. The administrator also observed that several users are reporting intermittent connectivity to some of the applications they are accessing. Other users are reporting no access to these applications. Other users at some of the branches claim they cannot get to certain public resources. The administrator wants to ensure that all sites can talk to each other and all resources are accessible.

Exhibit.

The tunnel from spoke to hub is not coming up. What are the two possible reasons? (Choose two.)

A. Spoke Edge and hub Edge are two different Edge models.

B. Spoke Edge and hub Edge have a mismatch certificate authentication mode.

C. Hub WAN Interface might be behind the NAT Device or firewall.

D. Dynamic Branch to Branch is not enabled.

Scenario 2:

After completing the branch activation activities for all required branches, the network administrator attempts to test connectivity between the various branches and between the hubs and branches. The administrator notices a lack of connectivity despite being certain that configurations have been complete. The administrator also observed that several users are reporting intermittent connectivity to some of the applications they are accessing. Other users are reporting no access to these applications. Other users at some of the branches claim they cannot get to certain public resources. The administrator wants to ensure that all sites can talk to each other and all resources are accessible.

Exhibit.

A network administrator is trying to create multiple overlays on a single physical interface on an Edge. The administrator is able to bring up only a single overlay so far, but is having trouble with bringing up additional overlays.

What could be the possible reason?

A. The administrator does not have the right permission to create multiple overlays. The administrator needs to have an Operator-level privilege for this task.

B. On the WAN overlay configuration, verify the IP address, next-hop, and the VLAN ID configuration.

C. The licensing does not support multiple overlays on a single physical interface.

D. Multiple overlays cannot be created on a single physical interface. Multiple physical interfaces are needed.