Which describes derived values and their relationship with Final Measurements?
A. Final Measurements can have multiple derived values, which represent other values for the same Final Measurement Date/Time.
B. Derived values can have multiple Final Measurements, which represent other values for the same Initial Measurement Date/Time.
C. Final Measurements can have one derived value, which represents an alternative for the same Final Measurement Date/Time.
D. Final Measurements can have one derived value, which represents the Initial Measurement for the same Final Measurement Date/Time.
Which configuration steps are required to derive loss-adjusted kWh on a measuring component based on a loss factor value related to a service point?
A. Configure a Service Point Characteristic Type and derivation algorithm, and then associate the algorithm to the Measuring Component Type and the characteristic value to the service point.
B. Configure an SQI and the derivation algorithm, and then associate the algorithm to the Measuring Component Type and SQI to the service point.
C. Configure a factor and derivation algorithm, and then associate the factor to the Measuring Component Type and the derivation algorithm to the service point.
D. Configure a factor and derivation algorithm, and then associate both to the Measuring Component Type and service point.
E. Configure a Service Point Characteristic Type, factor, derivation algorithm, and Service Quantity Identifier (SQI), and then associate the SQI and derivation algorithm to the Measuring Component Type and the characteristic value to the service point.
Within the application, operational devices can be assets or components.
Which two statements are true about components? (Choose two.)
A. Components are attached to assets.
B. Components have a disposition that tracks their location and status.
C. Components can be installed at locations.
D. Components are not a class of assets.
E. Components can't have specifications.
Which statement correctly describes the relation between a device and a measuring component?
A. A device configuration links a device only to interval channels.
B. Two measuring components on the same device should have the same Units of Measure (UOM).
C. A device should have only one measuring component type.
D. A device can have any combination of interval and/or scalar measuring components.
Which three statements are true in relation to Financial Transaction creation algorithms? (Choose three.)
A. They control how the payoff balance is affected.
B. They control when a Financial Transaction is to be swept onto a bill.
C. They control how the General Ledger details are created as these must always exist against a Financial Transaction.
D. They control if and how the General Ledger entries are created.
E. They control how the current balance is affected.
A usage subscription must exist before usage transactions can be calculated for a specific service point. Where do you configure the usage recipient?
A. in the Usage Rule Type
B. in the Service Point Type
C. in the Device Type
D. in the Measuring Component Type
E. in the Usage Subscription Type
What can cause multiple bill lines for a rate component to be produced in a bill calculation header?
A. changes in Rate Schedule and Bill Factor
B. changes in Rate Version Calculation Group and Bill Factor
C. change in Bill Factor
D. change in Rate Version Calculation Group
E. change in Rate Schedule
A device has one or more measuring components that measure consumption, demand, or other values.
Which lists two attributes of a measuring component?
A. Channel Multiplier and Channel ID
B. Channel ID and Badge Number
C. Serial Number and Badge Number
D. Model and Serial Number
E. Manufacturer and Model
How many bill segment-related financial transactions do Payment Arrangements have?
A. depends on the number of bills that will contain the customer's payment arrangement details
B. one
C. depends on the number of payments that are part of the payment arrangement
D. unlimited
E. none
Which statement is true about specifications?
A. Specifications include the inspection history of an asset.
B. Specifications apply only to assets and not to components.
C. Specifications can include peer specifications.
D. A single specification can only be used on one asset.