199-01 Online Practice Questions and Answers

Why should you use promiscuous mode on each in-path virtual NIC for Virtual Steelhead appliance? (Select 2)

A. For LAN/WAN Virtual NICs to intercept traffic not destined for the virtual machine

B. This configuration is mandatory for traffic optimization

C. Promiscuous mode is not required

D. Only verbose mode should be configured

E. Only regular mode should be configured

Which user roles and permissions are supported by the CMC appliance? (Select 3)

A. Read-Only

B. Read/Write

C. Write-Only

D. Deny

E. Accept

After deploying the Steelhead appliances in-path, you are not seeing any optimization between

10.11.0.128 and 10.11.23.18.

Look at the following trace in the exhibit and explain why: (HINT: Look at the SYN packet)

A. There is a spanning-tree loop

B. The cables are reversed

C. The three way hand-shake is not being completed

D. The client and servers are on the same /16 subnet

E. There is no SYN/ACK from 10.11.23.18

Which of the following commands would allow you to generate a system dump from the CLI?

A. sysdump

B. dump generate

C. debug generate dump

D. sysdump generate dump

E. dump generate -w filename

What is the priority bit order for WCCP MASK?

A. Source port, source IP, destination port, destination IP

B. Destination port, source port, destination IP, source IP

C. Source IP, destination port, destination IP, source port

D. Source port, destination port, source IP, destination IP

E. There is no priority order. It is weighted through bit assignments.

When would Simplified Routing Destination Only be used? (Select 2)

A. HSRP (Hot Standby Routing Protocol)

B. VLAN bridging

C. Multiple firewalls

D. Bridged network

E. There is no setting for Destination Only

When two or more Steelhead appliances are configured with Connection Forwarding in such environments as WCCP clustering, what feature will allow remaining Steelhead appliances to continue to provide optimization for new connections when one unit fails?

A. In-Path Neighbor FailurE. Allow

B. WCCP neighbor active

C. Minimum cluster count set to 1

D. Maximum cluster count set to 2

E. This cannot be done on Steelhead appliances

What port number is configured on a Steelhead appliance to communicate to the TACACS+ server?

A. 1645

B. 1646

C. 1812

D. 389

E. 49

What is the command to clear all statistics on a Steelhead appliance?

A. (config) # stats clear-all

B. (config) # clear-all stats

C. (config) # reset stats

D. (config) # reload stats clean

E. (config) # clear stats

When using Correct Addressing and enhanced auto-discovery (EAD), what is the size of the probe response in the return SYN/ACK packet from the server?

A. 4 bytes

B. 10 bytes

C. 14 bytes

D. 18 bytes

E. 32 bytes