What is the maximum amount of Appliances within Security group in Dual-Site configuration?
A. 16
B. 15
C. 28
D. 31
What is the purpose of g_tcpdump command?
A. Collects traffic dump from Sync network
B. The same as tcpdump, just on Scalable Platform
C. Collects traffic dump from CIN network
D. Collects traffic dump from all Active Appliances within Security Group
What cannot be learned from the output ofasg monitorcommand?
A. Appliances cluster status
B. Port status
C. Uptime
D. Security Policy status
In order to set Site (chassis) priority per VS, following command should be used:
A. From given VS context: set chassis high-availability vs chassis_priority
B. From given VSO context: set chassis high-availability vs chassis_priority
C. From any VS context: set chassis high-availability vs
D. From VSO context: set chassis high-availability vs
What is the default IP range of Sync network (with no increment)?
A. The same as Management network
B. 198.51.100.0
C. 192.0.2.0
D. 192.168.1.0
What command should be used for collecting diagnostic information about the orchestrator?
A. cpinfo
B. orch_info
C. cpview
D. asg pert -v
How many power supplies are presented on MHO-170?
A. 2
B. 1
C. 1 with option for 2
D. 4
Which is a valid requirement for a supported Maestro appliance?
A. 10GBps and 40Gbps or 100Gbps card with double-VLAN and LLDP support
B. At least one 10GBps line card
C. Nothing special as Maestro supports any Check Point appliance
D. Line card with double-VLAN and LLDP support
What does the command'g_all' do?
A. It's followed by other command and execute it on all active Appliances within Security Group
B. It's followed by other command and execute it on all Appliances connected to Orchestrator
C. Switches all Appliances to Global mode
D. Bring up all Appliances
Which command will be used in order to restart Orchestrator service only?
A. orchd restart
B. cpstop; cpstart
C. reboot
D. service orchestrator restart