132-S-900.7 Online Practice Questions and Answers

An Avaya customer with a large contact center is IP enabling their S87xx and will allow 25 users to work from home via IP Agent in the Telecommuter mode. What is the minimum hardware required in the S87xx to provide this application?

A. one CLAN board only

B. one Media Processor board only

C. one CLAN and one Media Processor board

D. no hardware is required, only software.

Within an S8500 Server, 25 IP Telephony endpoints are simultaneously connected to 10 digital sets, 10 IP sets, and 5 CO trunks. How many DSPs are in use on the TN2602AP Media Processor using a G.729 codec?

A. 15

B. 25

C. 30

D. 50

A client has an engineering location with ultra-high density LAN user requirements and a warehouse with very low-density user requirements. Which IEEE standard should be associated with each for a valid design? (Choose two.)

A. Low-density locations incorporate 802.11b.

B. Ultra-high density locations incorporate 802.11A.

C. Ultra-high density locations incorporate 802.11g.

D. Both high and low density users incorporate 802.11g.

A location has a single G700 Media Gateway with the following installed:

S8300 Media Server MM710 DS1 Module MM711 Analog Module

The enterprise uses all IP sets and soft phones in road warrior mode, and all use the G.729A codec and no encryption. They need to add a T1 facility. What is the minimum requirement necessary to accomplish this?

A. MM710 Media Module only

B. MM710 Media Module and G700 Media Gateway only

C. MM710 Media Module and MM760 Media Resource Module only

D. MM710 Media Module, MM760 Media Module, and G700 Media Gateway

Which is NOT a service performed by the SIP Enablement Services (SES) Server?

A. Proxy Server

B. Location Server

C. Session Boarder Controller

D. Registrar

In a distributed S87xx Media Server system with G650 Media Gateways in 3 port networks, what is the distance concern with the TDM cable length?

A. Due to the length of the TDM cable, the slack must be coiled and secured to the back of the PN.

B. The TDM cable can be ordered to custom fit the system. The designer must know the PN to G650 layout.

C. If the incorrect cable length attribute is chosen, it will not allow the associated G650s to connect to the PN.

D. Due to its limited length, each G650 of a PN must be co-located in the same 19 inch data rack as the rest of the PN.

Which two design issues relate to increasing security in VoIP converged solutions? (Choose two.)

A. suggesting upgrading LAN switches to support QoS

B. defining VLANs to limit access from specific IP endpoints

C. considering encryption on IP calls for protection from eavesdropping

D. considering G.729 compression to protect IP calls from eavesdropping

What are three methods for backing up an S8700 Media Server running Communication Manager 4.0? (Choose three.)

A. FTP

B. TFTP

C. HTTP

D. DHCP

E. PCMCIA Card

A complex design request has been issued for a "converged" environment. In the RFP, you expect to receive specific information in order to create a design solution. What information influences your design solution? (Choose three.)

A. Network topology

B. Estimated busy hour call load

C. Number and type of endpoints

D. Highpoint closet temperatures

E. Number of management offices

You outsource a call center that has more than 50 agents running IP Agent software. The router is performing Network Address Translation (NAT) on all private addresses in the call center to a public address of 207.89.3.8. Only one agent can log in because the media server assumes each additional login request from the same IP address is the same agent. Therefore, the current connection is dropped, and the new connection is established. What are two solutions for this problem? (Choose two.)

A. Create a VPN between the routers

B. Implement a one-to-one NAT scheme

C. Implement a one-to-many NAT scheme

D. Open ports 1719 and 1720 on the firewall